Simoco SRM9030 Uživatelský manuál stáhnout pdf (Strana 77)

MRMap Development Team 10/01/2009

Next to be programmed is the Input/Output values which are shown below.

Don’t be tempted to use ‘Valid Signal’ instead of ‘Carrier Detect’ as this means the data, which

doesn’t have a CTCSS tone attached, won’t enter the rebroadcast unit so only the voice signal is

sent.

Likewise ‘PTT Ext Data’ must be used rather than ‘PTT Ext’.

A ‘Data Volume’ of 15 as recommended earlier results in good but not ‘punchy’ audio. If you are

using the programming software set at Level 3 then you will also have access to the audio level

controls. None of these other than the ‘Compression Gain’ need to be changed but bringing this

up from 0 to 6 or even 12 will increase the level of transmitted audio without risk of distortion to

the GPS data.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 83

Zion Ernest 12 Oct 2024 | 04:24:45

Manual and program

Simoco SRM9030 Uživatelský manuál Strana 77